Oven laboratorium

Description

Oven laboratorium

Temperature
Working temperature range at least 5 (UN/UNplus/UNm/UNmplus) or 10 (UF/UFplus/UFm/UFmplus) above ambient temperature to +300 °C
Setting accuracy temperature
up to 99.9 °C: 0.1 / from 100 °C: 0.5 Setting temperature range +20 to +300°C
Temperature sensor 1 Pt100 sensor DIN class A in 4-wire-circuit
Control technology
Language setting German, English, Spanish, French, Polish, Czech, Hungarian
ControlCOCKPIT SingleDISPLAY. Adaptive multifunctional digital PID-microprocessor controller with high-definition TFT-colour display
Timer Digital backwards counter with target time setting, adjustable from 1 minute to 99 days Function SetpointWAIT the process time does not start until the set temperature is reached Calibration three freely selectable temperature values
adjustable parameters temperature (Celsius or Fahrenheit), air flap position, programme time, time zones, summertime/wintertime
Ventilation
Convection natural convection
Fresh air Admixture of pre-heated fresh air by electronically adjustable air flap Vent vent connection with restrictor flap
Communication
Documentation programme stored in case of power failure
Programming AtmoCONTROL software for reading out, managing and organising the data logger via Ethernet interface (temporary trial version can be downloaded). USB stick with AtmoCONTROL software
available as accessory (on demand).
Safety
Temperature control adjustable electronic overtemperature monitor and mechanical temperature limiter TB, protection class 1 according to DIN 12880 to switch off the heating approx. 20°C above nominal temperature
Autodiagnostic system for fault analysis

Safety
Temperature control adjustable electronic overtemperature monitor and mechanical temperature limiter TB, protection class 1 according to DIN 12880 to switch off the heating approx. 20°C above nominal temperature
Autodiagnostic system for fault analysis
Standard equipment
Door fully insulated stainless steel door with 2-point locking (compression door lock) Internals 1 stainless steel grid(s), electropolished
Works calibration certificate Calibration at +160°C
Stainless steel interior
Interior easy-to-clean interior,made of stainless steel, reinforced by deep drawn ribbing with integrated and protected large-area heating on four sides
Volume 53 l
Dimensions w(A) x h(B) x d(C): 400 x 400 x 330 mm Max. number of internals 4
Max. loading of chamber 80 kg Max. loading per internal 20 kg Textured stainless steel casing
Dimensions minimal w(D) x h(E) x d(F): 585 x 784 x 514 mm (d +56mm door handle) Housing rear zinc-plated steel
Electrical data
Voltage
Electrical load 230 V, 50/60 Hz approx. 2000 W Voltage
Electrical load 115 V, 50/60 Hz approx. 1700 W

Ambient conditions
Set Up The distance between the wall and the rear of the appliance must be at least 15 cm. The clearance from the ceiling must not be less than 20 cm and the side clearance from walls or nearby appliances
must not be less than 5 cm.
Altitude of installation max. 2,000 m above sea level Ambient temperature +5 °C to +40 °C
Humidity rh max. 80 %, non-condensing Overvoltage category II
Pollution degree 2